Recovers a disk or volume backup onto a new or existing virtual machine. The recover vm command replaces and enhances the convert command which was available in earlier versions of the Acronis software.
The recover vm command can be executed by the following agents:
Files of the fully configured and operational machine will be placed in the folder you select. You can start the machine using the corresponding virtualization software or prepare the machine files for further usage. The OVA virtual appliance can be imported to XenServer. Disks of a Virtual PC can be attached to a Hyper-V virtual machine.
A virtual machine must be powered off during the recovery to this machine. The target machine located on an ESX(i) or Hyper-V host will be powered off without a prompt. Please be sure to specify the correct machine.
Parameters
What to recover
--loc=<path>
--credentials=<user name>,<password>,encrypted
--arc=<archive name>
--password=<password>,encrypted
--backup=<backup ID>
--disk=<disk numbers>
--volume=<volume number>
Where to recover
Credentials for a network folder where the virtual machine is to be created.
--target_disk=<disk number>
--target_volume=<volume number>
--start=<offset>{s|kb|mb|gb}
--size=<volume size>{s|kb|mb|gb}
How to recover
--ext2_3
--fat16_32
--preserve_mbr
--type={active|primary|logical}
--use_all_space
Recovery options
--force_yes
--power_on
--retry_count=<number of attempts>
--retry_delay=<delay>
--silent_mode={on|off}
--use_registry_defaults
General parameters
--log=<full path>
--log_format={structured|unstructured}
--output={formatted|raw}
--progress
{-f|--file_params}=<full local path>
Access to a remote machine (Acronis Backup Advanced only)
--host=<IP address or hostname>
--credentials=<user name>,<password>,encrypted
Access to a specific service within a machine (Acronis Backup Advanced only)