These options enable you to specify how to handle errors that might occur during the restore operation. Select the Re-attempt if an error occurs check box for enabling the silent mode.
When a recoverable error occurs, the program re-attempts to perform the failed operation. You can set the Interval between attempts and the Number of attempts. The task finishes as soon as the restore operation succeeds OR the specified number of attempts is reached.
If you select the Re-attempt if an error occurs check box, set up the Number of attempts and the Interval between attempts. This option is enabled by default with the following settings: Number of attempts – 5, and Interval between attempts – 30 seconds. For example, if the restore network destination becomes unavailable or not accessible, the program will attempt to reach the destination every 30 seconds, but no more than 5 times. The attempts will be stopped as soon as the connection is resumed or if the specified number of attempts is reached.
Select the Cancel all task operations upon failure check box, for example, if you need to restore a number of interconnected VMs. Then in case of failure in restoring a single VM, all other restore operations will also be cancelled.